Page tree
Skip to end of metadata
Go to start of metadata

General Info.

This is in no case an exhaustive configuration procedure, It's a simple guide on how to configure these switches to use them with Ravenna/AES67 networks.

Connecting several Cisco switches together requires additional configuration.
Please also see the Multiple network switches considerations page and Cisco SG300/350 Multiple switches configuration guide.

IMPORTANT NOTE ON IP ADDRESS RANGE :
The Internet Engineering Task Force (IETF) has directed the Internet Assigned Numbers Authority (IANA) to reserve the following IPv4 address ranges for private networks:
192.168.0.0 to 192.168.255.255 / 172.16.0.0 to 172.31.255.255 / 10.0.0.0 to 10.255.255.255.
Private IPs should only be in these ranges (see https://en.wikipedia.org/wiki/Private_network )


Table of contents.


1. Access SG300-10&20 Administration

  • Accessing the configuration page.
  • Changing the default user password.

2. Setup 1 - Single VLAN.

  • Change Switch IP.
  • Change IGMP settings.
  • Change Green Ethernet settings.
  • Change QoS settlings.

3. Setup 2 - Dual VLAN

  • Adding a VLAN
  • Change VLAN IP Address
  • Change IGMP settings.
  • Change Green Ethernet settings.
  • Change QoS settlings.

4. Backup Switch Configuration

  • Backup Running Configuration
  • Backup Backup Configuration
  • Backup Default Configuration

5. Import Switch Configuration.

  • Import configuration from a file.
  • Save configuration to running config.

6. Upgrade Switch Firmware.

  • Download latest Firmware
  • Install latest Firmware



  • No labels