Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  • Merging RAVENNA/AES67 device
    Horus and Hapi running Firmware 3.10.0 or above.
    Anubis running Firmware 1.2.2. or above 
  • Gigabit Ethernet network
    (A Gigabit Ethernet adapter is required in order to connect to a USB A, B or C or Thunderbolt port).
  • MacOS Catalina - BigSur
  • Virtual Audio Device driver installed (please follow the instructions in the Virtual Audio Device guide)
  • Unite is not supported in ST2022-7 mode. Under the Anubis Settings>General, the Network ST2022-7 mode should be disabled.


Unite simplifies your AoIP connectivity by bringing you a quick automatic stream patching.

  1. Browse to the MAC System Preferences, in Other open the Merging RAVENNA icon to open the driver panel.
    If you have several network adapters, please select the one connected to your Merging device in the Network Adapter section.
  2. Select the UNITE mode tab (left side)


  3. Click on one of the Device made available for you to UNITE.
    In example below we will UNITE the Anubis.


  4. This will open a menu from where you can select the IO’s that will be Automatically Connect and available in your application.

    Note : The available inputs or outputs depends of the device you want to Unite with (see table below).

  5. Checkmark the IO’s you wish to automatically connect.
    Note: The IO channel count setting will be automatically adjusted if more IO's are required.

  6. Once selecting Unite the AoIP connections between the Device and the VAD will automatically be made.

...

  1. Start the Merging Audio Device panel.
    If you have several network adapters, please select the one connected to your Merging device in the Network Adapters section.
  2. Select the UNITE mode tab.


  3. Click on one of the Device made available for you to UNITE.
    In example below we will UNITE the Anubis.


  4. This will open a menu from where you can select the IO’s that will be Automatically Connect and available in your application.

    Note : The available inputs or outputs depends of the device you want to Unite with (see table below).

  5. Checkmark the IO’s you wish to automatically connect.
    Note: The IO channel count setting will be automatically adjusted if more IO's are required.

  6. Once selecting Unite the AoIP connections between the Device and the MAD will automatically be made.

...